Wps; General Wireless Lan Screen - ZyXEL Communications wap3205 V3 User Manual

Usually, you should set up the strongest encryption that every wireless client in the wireless network
supports. Suppose the wireless network has two wireless clients. Device A only supports WEP, and device
B supports WEP and WPA2-PSK. Therefore, you should set up WEP in the wireless network.
Note: It is recommended that wireless networks use WPA2-PSK, or stronger encryption. IEEE
802.1x and WEP encryption are better than none at all, but it is still possible for
unauthorized devices to figure out the original information pretty quickly.
Many types of encryption use a key to protect the information in the wireless network. The longer the
key, the stronger the encryption. Every wireless client in the wireless network must have the same key.

6.3.4 WPS

WiFi Protected Setup (WPS) is an industry standard specification, defined by the WiFi Alliance. WPS
allows you to quickly set up a wireless network with strong security, without having to configure security
settings manually. Depending on the devices in your network, you can either press a button (on the
device itself, or in its configuration utility) or enter a PIN (Personal Identification Number) in the devices.
Then, they connect and set up a secure network by themselves. See how to set up a secure wireless
network using WPS in the

6.4 General Wireless LAN Screen

Use this screen to enable the Wireless LAN, enter the SSID and select the wireless security mode.
Note: If you are configuring the WAP3205 v3 from a computer connected to the wireless LAN
and you change the WAP3205 v3's SSID, channel or security settings, you will lose your
wireless connection when you press Apply to confirm. You must then change the
wireless settings of your computer to match the WAP3205 v3's new settings.
Click Network > Wireless LAN to open the General screen.
Figure 36 Network > Wireless LAN > General (Access Point Mode)
Chapter 6 Wireless LAN
Section 5.3 on page 44.
WAP3205 v3 User's Guide
56