Setting Your Wap3205 V3 To Client Bridge Mode - ZyXEL Communications wap3205 V3 User Manual

Table 15 Menu: Universal Repeater Mode (continued)
LINK
WLAN
LAN
Maintenance
System
Logs
Tools
Operation
Mode

4.4 Setting your WAP3205 v3 to Client Bridge Mode

Connect your computer to the LAN port of the WAP3205 v3.
1
The default LAN IP address of the WAP3205 v3 is 192.168.1.2. You give your computer a fixed IP address in
2
the range between 192.168.1.3 and 192.168.1.254
After you've set your computer's IP address, open a web browser such as Internet Explorer and type the
3
IP address of the WAP3205 v3 as the web address in your web browser.
Log into the Web Configurator. See the
4
Go to Operation Mode > General and select Client Bridge.
5
Chapter 4 Modes
TAB FUNCTION
AP Select Use this screen to choose an access point that you want the WAP3205 v3 to
connect to. You should know the security settings of the target AP.
General Use this screen to configure wireless LAN.
MAC Filter Use the MAC filter screen to configure the WAP3205 v3 to block access to
devices or block the devices from accessing the WAP3205 v3.
Advanced This screen allows you to configure advanced wireless settings.
WPS Use this screen to configure WPS.
WPS Station Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
IP Use this screen to configure LAN IP address and subnet mask.
General Use this screen to view and change administrative settings such as system
and domain names, password and inactivity timer.
Time Setting Use this screen to change your WAP3205 v3's time and date.
View Log Use this screen to view the logs for the categories that you selected.
Firmware Use this screen to upload firmware to your WAP3205 v3.
Configuration Use this screen to backup and restore the configuration or reset the factory
defaults to your WAP3205 v3.
Restart This screen allows you to reboot the WAP3205 v3 without turning the power
off.
Language This screen allows you to select the language you prefer.
General This screen allows you to select the device operating mode: Access Point,
Universal Repeater or Client Bridge.
Chapter 2 on page 14
WAP3205 v3 User's Guide
(Section 2.2 on page
for instructions on how to do this.
40
14).