Table of Contents
Advertisement
Chapter 7 Network Settings
7.9 WPS
Use this screen to configure WiFi Protected Setup (WPS) on your WiMAX Device.
WPS allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. Set up each WPS connection
between two devices. Both devices have to support WPS.
Click Network Setting > WLAN > WPS to open this screen as shown next.
Figure 41 WPS Screen
This screen contains the following fields:
Table 32 WPS
LABEL
Enable WPS
Start WPS PBC
7.10 MAC Address Filter
Use these screens to configure a MAC (Media Access Control) address filter to
restrict access to the wireless network.
100
DESCRIPTION
Select Enable and click Apply to activate WPS on the WiMAX Device.
Select Disable and click Apply to deactivate WPS.
This field is available after you select Enable in the Enable WPS field
and click Apply.
Click this to add another WPS-enabled wireless device (within wireless
range of the WiMAX Device) to your wireless network. This button may
either be a physical button on the outside of device (such as the
WIRELESS ON/OFF button on the IDU), or a menu button similar to
the Start WPS PBC on this screen.
Note: You must press the other wireless device's WPS button
within two minutes of pressing this button.
MAX318M2W User's Guide
Advertisement
Table of Contents
