NETGEAR WAC104 User Manual page 47

The Home page displays.
4. Select Advanced Setup > IP Settings.
The previous figure shows that the access point's DHCP client is enabled.
5. Configure the IP settings by taking one of the following actions:
• Disable the DHCP client and configure a static IP address by doing the following:
a. Select the Use fixed IP Address (not recommended) radio button.
b. Enter the IP address information that you collected in the IP Address, IP Subnet Mask, Gateway
IP Address, Primary DNS, and Secondary DNS fields.
• Enable the DHCP client by selecting the Get dynamically from existing router radio button.
Note If you want to disable the DHCP server but do not want to use a static IP address,
you must reset the access point to factory default settings (see
Point to Its Factory Default Settings
6. Click the Apply button.
Your settings are saved and the access point restarts. After the access point becomes available again,
to log in to the access point web management interface, you must use either the static IP address that
you configured or the IP address that the DHCP server assigned to the access point.
802.11ac Wireless Access
Manage the Access Point and Monitor the Traffic
on page 44).
47
Return the Access