Suzuki GSF600Y 2000 Service Manual page 74

3-36 ENGINE
• Install the clutch push piece 1, clutch release bearing 2 and
thrust washer 3 onto the countershaft.
• Hold the starter clutch using the special tool, install the clutch
pressure plate, and then tighten the clutch spring set bolts in a
crisscross pattern to the specified torque.
( 09920-34810: Starter clutch holder
" Clutch spring set bolt: 12 N . m (1.2 kgf . m, 8.5 lb-ft)
• Apply a light coat of the recommended bond to the clutch cover
gasket mating surface A as shown.
* 99000-31140: SUZUKI BOND "1207B"
• Install the dowel pins, a new gasket and the clutch cover.
• Tighten the clutch cover bolts securely.
NOTE:
Install the two gasket washers onto the clutch cover bolts B as
shown.
$
Use only new gasket washers to prevent oil leakage.
• Apply a light coat of the recommended bond to the starter clutch
cover gasket mating surface C as shown.
* 99000-31140: SUZUKI BOND "1207B"