Remounting - Suzuki GSF600Y 2000 Service Manual

4-22 FUEL SYSTEM
THROTTLE POSITION SENSOR POSITIONING
Install the throttle position sensor as described below.
• Measure the resistance Ω
sor terminals as shown.
' Throttle position sensor resistance Ω Ω Ω Ω Ω
• Measure the resistance Ω
sor terminals as shown.
• Fully open the throttle valve with the throttle lever.
• Position the throttle position sensor until resistance Ω
– 4.63 kΩ.
• When the resistance Ω
throttle position sensor mounting screws.
' Throttle position sensor resistance Ω Ω Ω Ω Ω

REMOUNTING

Remount the carburetor assembly in the reverse order of removal.
Pay attention to the following points.
CARBURETOR CLAMPS
Position the carburetor clamps as shown.
L. H
between the throttle position sen-
1
: Approx. 5 kΩ Ω Ω Ω Ω
1
between the throttle position sen-
2
is within specification, tighten the
2
:
2
3.09 – 4.63 kΩ Ω Ω Ω Ω
#1 #2
Carburetor clamp position (air cleaner side)
#1 #2
Carburetor clamp position (engine side)
is 3.09
2
#3 #4
#3 #4
R. H