Suzuki GSF600Y 2000 Service Manual page 188

5-24 CHASSIS
• Tighten the steering stem head nut to the specified torque.
" Steering stem head nut: 65 N . m (6.5 kgf . m, 47.0 lb-ft) " "
" "
NOTE:
Before tightening the steering stem head nut, temporarily install
the front forks.
HANDLEBAR AND FRONT FORK
• When remounting the front fork, align the upper surface of the
inner tube with the upper surface of the steering stem upper
bracket.
• Tighten the front fork lower pinch bolts 1 and front fork upper
pinch bolt 2 to the specified torque.
" Front fork lower pinch bolt 1: " "
" "
23 N . m (2.3 kgf . m, 16.5 lb-ft)
Front fork upper pinch bolt 2:
23 N . m (2.3 kgf . m, 16.5 lb-ft)
• Set the handlebar to match its punched mark to the mating
surface of the handlebar holder.
• Set the punched mark on the handlebar holders as shown in
the photograph.
• Tighten the handlebar holder bolts 3.
NOTE:
First tighten the handlebar holder bolts A to the specified torque.
" " " Handlebar holder bolt: 23 N . m (2.3 kgf . m, 16.5 lb-ft) " "
• Install the front wheel. (! 5-11)
FWD
Clearance