Suzuki GSF600Y 2000 Service Manual page 238

6-14 ELECTRICAL SYSTEM
GENERATOR DRIVEN GEAR DAMPERS
Inspect the generator driven gear dampers for wear and dam-
age. If any defects are found, replace the generator driven gear
dampers as a set.
NOTE:
When installing the generator driven gear dampers, apply SUZUKI
MOLY PASTE to the damper surface.
) 99000-25140: SUZUKI MOLY PASTE
STATER COIL CONTINUITY CHECK
Measure the continuity between the lead wires of the stator coil
using a tester.
If there is no continuity, replace the stator.
Also, check that the stator is properly insulated.
# 09900-25008: Multi circuit tester set # # # #
* * * Tester knob indication: Continuity test (+ * *
ROTOR COIL CONTINUITY CHECK
Measure the continuity between the two slip rings 1 on the
rotor coil using a tester.
If there is no continuity, replace the rotor.
Also check that the rotor is properly insulated.
SLIP RINGS
If the slip rings are dirty, polish them with #400 sandpaper and
wipe them using a clean, dry cloth.
Then, measure the slip ring O.D. using vernier calipers. If it is less
than the service limit, replace the slip rings with new ones.
# 09900-20102: Vernier calipers (200 mm)
$
Slip ring O.D.
Service Limit: 14.0 mm (0.55 in)
+ ) + + +
P
P
3
2
P
4
P
1
P
2
P
3
P
4
P
1