System Operations (Only For The S5-95U); Set Operations (Only For The S5-95U); Load And Transfer Operations - Siemens SIMATIC S5-90U System Manual

STEP 5 Operations
8.3

System Operations (only for the S5-95U)

System operations and supplementary operations have the following limitations.
• You can program them only in function blocks.
• You can program them only in the STL method of representation.
Since system operations access system data, only users with system knowledge should use them.
If you want to program system operations, you must select "SYS: OPS. Y" in the programmer
presets menu.
8.3.1

Set Operations (only for the S5-95U)

Like the supplementary bit operations, these set operations can change individual bits. Table 8-26
provides an overview of the set operations.
Operation Operand
SU
RU
ID
RS
Processing Set Operations
Execution of set operations does not depend on the RLO.
8.3.2

Load and Transfer Operations

Use these load operations and transfer operations to address the entire program memory of the
programmable controller. They are used mainly for data exchange between the accumulator and
memory locations that cannot be addressed by operands. Table 8-27 provides an overview of the

load and transfer operations.

8-64
Table 8-26. Overview of Set Operations
Set bit unconditionally
A specific bit is set to "1" in the system data area.
Reset bit unconditionally
A specific bit is set to "0" in the system data area.
Parameter
Meaning
0.0 to 255.15
EWA 4NEB 812 6115-02b
S5-90U/S5-95U