General Information Regarding The Configuration; Changing, Setting-Up Or Checking The Configuration - Roland udk20 Manual

B0048991 / Rev. 1.3
7.4

General information regarding the configuration

The following rules apply to the operation in the configuration mode:
• The configuration mode is activated (while in measurement mode) by pressing the MENU
key.
• The configuration mode is terminated or cancelled by pressing the MENU key.
• The selected / set parameters can be changed when the items are blinking in the display.
• The selected / set parameters are activated by pressing the ENTER key.
Pos: 55 /Doppelblech/Geräte/UDK20/7 Inbetriebnahme/Ändern, Anlegen, Kontrollieren der Konfiguration @ 1\mod_1310624070648_501.doc @ 9538 @ 2 @ 1
7.5

Changing, setting-up or checking the configuration

In order to select, set-up or check the system / program parameters, press the MENU key.
The following menu is shown.
configuration
review
Fig. 31: Indication after calling-up the menu
This menu option permits either reviewing or changing the configuration.
Configuration review: The system / program parameters cannot be changed.
Configuration change: All system / program parameters can be changed after entering the
The following menu option is shown.
password
4711
Fig. 32: Password request
Each blinking digit can be changed with the arrow keys and confirmed with ENTER. After having
entered the correct password, the following menu appears for the adjustment of the configuration
mode.
If the entered password is incorrect then the cursor returns to the first digit of the password and the
input must be repeated. The input of the password can be aborted by pressing the MENU button.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series UDK20
Note
The correct configuration depends on the communication with the PLC,
on the measurement task and the connected components.
The measurement mode is not interrupted.
password.
Note: A fault is generated if PLC commands are executed while entering the
password or changing parameters.
Manual
Start-up
83