Discharging A Patient/Ending A Case - Philips V24CT User's Reference Manual

Discharging
Patient data for the current patient can be erased in the Patient
a Patient/
Information Task Window under
Ending a
(ICU configuration sets) or the End Case Task Window under
Case
Procedures
in ICU Configuration Sets erases the entire patient database. You must
press
Admit Patient Task Window.
erases the entire database. Additionally, the monitor resets all settings to
the user defaults and then returns to Monitor Standby. You must press
Confirm
report is printed prior to ending the case.
Note—
defaults. To do this manually press
-->
Confirm
If the monitor is connected to a Philips Documentation Center and
arrhythmia is assigned, arrhythmia must be unassigned under
station, discharge must be performed at central as well. The discharge
procedure is not complete until the patient's information is erased from
all parts of the system and the system is available for a new patient.
During a transfer to or from the M1235A Data Transfer Module, the
Discharge Patient and End Case Task Windows are not available.
-->
End Case
Pts
Refernce
for the discharge to take effect. The system returns to the
Confirm
for the discharge to take effect. If configured, a scheduled
In ICU configuration not all settings are automatically reset to user
.
Change ConfSet
Pts
Refernce
.
. If the monitor is connected to a Philips central
Arrhyth Functns
Pts
Refernce
Procedures
(OR configuration sets).
in OR Configuration Sets also
End Case
Pts
Refernce
Monitor Setup
Do not change the selection and then press
Admit/Discharge/End Case 7-9
Admitting a Patient
-->
Discharge Patient
Pts
Refernce
Discharge Patient
Pts
Refernce
-->
Adult/Pedi/Neo
Pts
Refernce