Table of Contents
Advertisement
INSTANT LED
This LED/display indicates that the system has been armed in the INSTANT or STAY/INSTANT mode,
meaning that the system is currently armed, all delay zones are instant (no entry delay time).
ON
Delay zones are currently instant
OFF
Delay zones are normal
See Programming Question 19, Location 1 for various Instant arming options.
AC/LOW BATTERY LED
This LED/display indicates the current power status of the panel as follows:
ON
AC is present
OFF
No AC, running on battery backup
Slow Blink
Low-battery condition detected
READY LED
This LED/display indicates that the system is ready for arming. The READY LED is common to all
BURGLARY ZONES, with the following indications:
ON
System ready to be armed
OFF
System not ready to be armed
Slow Blink
Installer Programming Mode
Fast Blink
Alarm Memory Mode
TX LB
This LED will pulse whenever any point is in a low battery condition. Any zone in a low battery
condition will also pulse.
RF SPRV
This LED has the following supervisory indications:
OFF
No supervisory conditions exist
ON
A transmitter has not checked in at the specified supervisory time
Pulsing
Bell is in supervision
Blinking
A 5800 point reports a tamper condition; Zone LED is normally off
[STAY] BUTTON
The [STAY] button arms the system, excluding zones programmed as interior zones. This provides
exterior protection of the premises while allowing full access throughout the interior.
[BYPASS] BUTTON
The [BYPASS] button is used to temporarily exclude protection to a specific zone(s).
[INSTANT] BUTTON
If pressed, the [INSTANT] button allows arming the system in the INSTANT mode and, with the
[STAY] button, it enables arming the system in the STAY/INSTANT mode.
NOTE: INSTANT mode is enabled in Question 10, L3.
[CODE] BUTTON
The [CODE] button is used to allow entry into the Installer Programming Mode and permits the entry
of user codes.
Section 4 – System Operations
4–3
Hide quick links:
Advertisement
Table of Contents
