Data Entry Via Lcd Keypad - Honeywell OMNI 408 Installation And Setup Manual

OMNI-408/OMNI-408EU Installation and Setup Guide
VALUE
A
B
C
Example: To enter an A, press the [Code] key followed by the [1] key.
The keypad chirps on each keystroke. In addition, a beep confirms advancement between question
numbers.
Four beeps signify an invalid input entry. After you make an invalid entry, the system positions you at
the same question number and location as immediately before you made the invalid entry.
Exit System Program Mode
After all programming has been completed, press the [Stay] key to exit the system Program mode.

Data Entry via LCD Keypad

The following paragraphs provide an explanation of how to use an LCD keypad for data entry.
Enter Programming Mode via Keypad
The System Programming mode can be entered ONLY WHILE DISARMED, as follows:
To enter Installer Programming: Press [Code] [*] 4-digit Installer code (default 2468). The keypad
displays:
Press [1]. The keypad displays:
The information displayed has the following meanings:
9–4
KEYSTROKES
[Code] [1]
[Code] [2]
[Code] [3]
Question Acknowledgment
Installer modes
Enter 1-7
Q#01 Edit
DATA:XXXX
Current Edit indicates that
Question you are in Installer
Number Programming
Q#01 Edit
DATA:XXXX
XXXX = Content of Question or
Location. Blinking character
indicates data that will be
changed by a key entry
VALUE KEYSTROKES
D [Code] [4]
E [Code] [5]
F [Code] [6]
L01
System
Current
Location
Number
L01
System
Displays System
for system
questions or
ZR401 for RF
questions