• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o
Entering Installer Modes
o
Installer Mode 1 (Installer Keypad
Programming)
o
Installer Mode 2 (Read Only Mode)
o
Installer Mode 3 (Unattended Download)
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Entering Installer Modes
There are 7 installer modes in the panel.
To enter installer modes: press [Code] [*], Installer Code, X
Where:
Installer code = The 4-digit Installer Code (default = 2468)
X = The single digit indicating the Installer mode, as follows:
1
Installer Keypad Programming
Press [1] and [3] (at the same time)
Press [7] and [9] (at the same time)
Press [*] and [#] and XX
2
Read Only Mode
3
Unattended Download
4
On-line Download
5
Walk Test (Reduced Gain) Mode
6
Clear Tampers
7
System Log View
Installer Mode 1 (Installer Keypad Programming)
Installer Mode 1 enters the installer into the Keypad Programming mode. Refer to Section 9: Data
Entry Via Keypads.
The Compass Windows Downloader software contains an option to inhibit keypad programming. If you
select it, you will hear a negative acknowledgment (4 short beeps) after you attempt to enter this mode.
The software has another option (Default Lockout) to inhibit a different installer from defaulting the
panel and entering keypad programming. This prevents hostile account takeovers.
Installer Modes
o
Installer Mode 4 (On-Line Download)
o
Installer Mode 5 (Walk Test - Reduced Gain
Mode)
o
Installer Mode 6 (Clear Tampers)
o
Installer Mode 7 (System Log View)
System Default
User Code Default
RF Programming or Press [BYPASS] XX (selectable
in Question 07, L4)
S E C T I O N
6–1
6