Mounting The Receiver And Antennas - Honeywell OMNI 408 Installation And Setup Manual

OMNI-408/OMNI-408EU Installation and Setup Guide
SCREW
(2)
GROUNDING
LUG
(2)
CABINET
RF RCVR
PC BOARD
ANTENNA AND GROUNDING LUG INSTALLATION
6. Place the washer provided over the wire jumpers located within the middle of the PC board. Secure
the PC board to the middle-mounting clip of the enclosure through the washer, using the screw
provided.
7. Secure the remaining sides of the PC board to the enclosure, using the screws provided.

Mounting the Receiver and Antennas

1. Mount the receiver board on top of the control PC board as shown in the figure above.
2. Insert grounding lugs (supplied) into the left-hand terminals of the antenna blocks and secure them
to the cabinet with the screws provided.
3. Insert the receiver's antennas through the top of the cabinet into the block's right-hand terminals.
Tighten screws.
3–2
KNOCKOUT
ANTENNA
(2)
A
DETAILED SIDE VIEW
OF CLIP INSTALLION:
ANTENNA
A. CABINET TAB
MOUNT
WITHOUT CLIP
(2 PLACES)
B. CABINET TAB
WITH HANGING
CLIP
Figure 1. Mounting the Control Board
ANTENNAS
(INSERT IN
RIGHT-HAND
TERMINALS)
RF
RECEIVER
PC BOARD
CABINET
B
3rd CLIP
REQUIRED
DETAILED SIDE VIEW
OF BOARD INSERTED
INTO SLOTS
DETAILED SIDE VIEW
OF CLIP AND BOARD
INSTALLED