Honeywell OMNI 408 Installation And Setup Manual page 97

In the event of telephone operational problems, disconnect the control by removing the plug from the
RJ31X wall jack. We recommend that your certified installer demonstrate disconnecting the phones on
installation of the system. Do not disconnect the phone connection inside the control/communicator.
Doing so will result in the loss of your phone lines. If the regular phone works correctly after the
control/communicator has been disconnected from the phone lines, the control/communicator has a
problem and should be returned for repair. If upon disconnection of the control/communicator, there is
still a problem on the line, notify the telephone company that it has a problem and request prompt repair
service. The user may not under any circumstances (in or out of warranty) attempt any service or repairs
to the system. It must be returned to the factory or an authorized service agency for all repairs.
This control unit was manufactured under rigid quality standards and complies with all UL
requirements for its intended use. Maintenance is best performed by your installing company
with trained service personnel.
OMNI-408 and OMNI-408EU are in conformity with the essential requirements as
described in Directive 1999/5/EC and satisfy all the technical regulations applicable
to the product within this directive
EN 50081-1:1992
This apparatus has been assessed for connection to the following circuits
Public Switched Telephone Networks (PSTN) -non DDI
Private Branch Exchange (PBX)
TELEPHONE OPERATIONAL PROBLEMS
O560 DECLARATION OF CONFORMITY
EN 50130-4:1998
Appendix D – Regulatory Statements
EN 60950:1992 TBR 21
D–3