Section 4 - System Operations; Power-Up/System Reset; Keypads - Honeywell OMNI 408 Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o

Power-Up/System Reset

o

Keypads

o
Keypad Sounder
o
Keypad Backlight Timer
o
Keypad Addressing
o
Arming the System
o
Reset
o
Bypass
o
Subsequent Bypasses
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Power-Up/System Reset
When the system is in an armed state only, it may enter System Stabilization Mode. This occurs upon
power-up of the system, and causes all of the LEDs on the keypad(s) to light, and then go off for
approximately 2 minutes (if system was previously armed). This occurs on a total power-up or system
reset. If total system power is lost, upon power restoration, the system returns to the previous arming
state. The 2-minute, 10-second interval is used to allow motion detectors (in interior zones) to stabilize
on power-up in order to prevent false alarms. THIS OPTION CAN BE DISABLED BY PUTTING A
MOMENTARY JUMPER BETWEEN TERMINALS 15 AND 16 ON POWER-UP. IF DISABLED, THE
POWER-UP RESET TIME IS APPROXIMATELY 10 SECONDS. This is a normal condition.
Keypads
The OMNI-408 supports the following keypads:
OMNI-LCD Alpha Keypad
System Operations
o
Quick Bypass
o
Exit Bypass
o
Auto Unbypass
o
Manual Unbypass
o
User Code Programming
o
User Deletion
o
Keypad Emergency Conditions
o
Pager Follow-Me Displays
o
Entering Pager Follow-Me Phone Numbers
OMNI-LCD-US Alpha Keypad
S E C T I O N
3
1 2 STAY
6
4 5 BYPASS
8 9
7 INSTANT
0 # CODE
*
XK-7LC_kypd
XK7LC Alpha Keypad
4
4–1