Bracket Mounting Procedure; Figure 6 - St 700 Standard Transmitter - Angle Mounting Bracket Secured To A Horizontal Or; Table 5 - St 700 Standard Transmitter - Mounting Bracket Procedure - Honeywell ST 700 User Manual

4.4.4 Bracket Mounting Procedure

If you are using an optional bracket, start with Step 1. For an existing bracket, start with Step 2.
1. Refer to Figure
(60.4mm) actual OD) for a horizontal or vertical pipe, and install a "U" bolt around the pipe
and through the holes in the bracket. Secure the bracket with the nuts and lock washers
provided.
Mounting
Bracket
Horizontal Pipe
Figure 6 – ST 700 Standard Transmitter - Angle Mounting Bracket Secured to a Horizontal or
2. Align the appropriate mounting holes in the Transmitter with the holes in the bracket. Use the
bolts and washers provided to secure the Transmitter to the bracket; see the following
variations.

Table 5 - ST 700 Standard Transmitter - Mounting Bracket procedure

DP with double-ended process heads and/or
remote seals
ST 700 Standard transmitter models only.
In-line GP: STG7x0 and STG7xL
AP models: STA7xL and STA72x, STA740
Dual-head GP and AP
Example: Inline model mounted to an optional angle bracket. See
Revision 8.0
6. Position the bracket on a 2-inch (50.8mm nominal diameter, 2.38"
Nuts and
Lockwashers
U-Bolt
Vertical Pipe
Transmitter Type
ST 700 SmartLine Pressure Transmitters User's Manual
U-Bolt
Vertical Pipe
Use Hardware
Alternate mounting holes in the ends of
the heads
The smaller "U" bolt provided to attach the
meter body to the bracket. See the
following example.
Mounting holes in the end of the process
head.
Figure 7.
Nuts and
Lockwashers
Mounting
Bracket
Page 13