Data Entry; Editing A Numeric Value; Selecting A New Setting From A List Of Choices; Table 14 -Two-Button Data Entry - Honeywell ST 700 User Manual

5.3.3 Data Entry

Data entry is performed from left to right. Select a character / digit by pressing  buttons, and then
press  to advance to the next character position to the right. Select the cross-hatch character ▒ to
terminate the entry or if the final character is already a space character, just press << again.
All numeric entries are clamped at the low or high limit if needed. You can determine the low and
high limit for a parameter by selecting either the H or L character while the cursor is positioned over
the left-most digit and press  button. The Display will show the selected limit.
For numeric entry sign is required to be entered only for negative numbers. For positive number,
select space and move ahead.

5.3.4 Editing a Numeric value

Editing a numeric value is a digit-by-digit process, starting with the left-most digit.

1. Press to begin the edit process.
2. The Standard Display will show the current value of the item on the lower line, left justified.
3. Press the  buttons to select the desired digit, and then press
the right.
4. After the last digit has been entered, press  one more time to write the new value to the
transmitter.

5.3.5 Selecting a new setting from a list of choices

Use the procedure described below to select a new setting for parameters that present a list of choices
(e.g. PV Display, Pressure Units, and so forth.).

1. Press to begin the edit process.
a. The Standard Display will show the current setting of the item on the lower line
2. Press the  buttons to scroll through the list of choices.

3. Press to make your selection. The new selection will be stored in the transmitter and will
be displayed on the lower line
Page 36
Table 14 –Two-Button Data Entry
Screen
Symbol
Display the high limit for this parameter.
H
This symbol only appears in the left-most
position of the data entry field.
Display the low limit for this parameter.
L
This symbol only appears in the left-most
position of the data entry field.
<<
Terminate the numeric entry
0 thru 9, These characters are used to enter
Minus, numeric values. The minus sign only
Decimal appears in the left-most digit.
ST 700 SmartLine Pressure Transmitters User's Manual
Numeric data entry

to advance to the next digit to
Revision 8.0