Bracket Mounting; Figure 4 - Stt750 Pipe Mount With Adapter Housing - Horizontal & Vertical - Honeywell STT750 Quick Start Installation Manual

Figure 4 – STT750 Pipe Mount with adapter housing - Horizontal & Vertical
* Note 1: In Figures 2, 3 and 4, Housing adapter may not be present on all transmitter
models. If the housing adapter is not present, subtract 24,5mm (0,96 inches) from the
dimension specified.
Refer to the User's manual for dimension drawings

Bracket Mounting

If you are using an optional bracket, start with Step 1.
1. Align the two mounting holes in the transmitter with the two slots in the
mounting bracket and assemble the (2) M8 hex cap screws, (2)
lockwashers and (2) flat washers provided. Rotate transmitter assembly
to the desired position and torque the M8 hex cap screws to 27,0 Nm/
20,0 Lb-ft maximum.
2. Pipe Mount Option: Refer to
Figure 5.
vertical pipe, and install a "U" bolt around the pipe and through the holes
Position the bracket on a 2-inch (50.8 mm) horizontal or
Quick Start Installation Guide 5