The Standard Display Menu; Figure 58 - St 700 Basic Transmitter - Two-Button Option - Honeywell ST 700 User Manual

Figure 58

13.2.1 The Standard Display Menu

The Standard Display Menu is implemented as one long single-level menu, after entering into Menu
mode, and will "wrap around" when it reaches the end of the menu. To enter Menu mode select
PV display mode. Operation is as follows:
6. Select <Exit Menu> and press
7. Use the  buttons to scroll through the list of menu items.
8. Press the  button to select an item in Menu mode for data entry or activation. When an item
is selected for data entry or activation, the cursor will jump to the lower line of the LCD to
allow editing of the value. No action is taken against a menu item until the user presses the
button.
9. If you want to abort a data entry operation, simply refrain from pushing any buttons for more
than 10 seconds; the data entry operation will time out and the original value of the selected
item will be preserved.
10. If you want to abort a menu operation, simply refrain from pushing any buttons for more than
60 seconds; the menu operation will time out and the exit from menu & it will show PV
value.
The menu is divided into Standard Menu and Extended menu which can be enabled and disabled
by Extended Menu Enable/Disable operation.
Note: The abort option is not available for Loop test parameter. The timeout for the DAC trim
operation is more to enable user to calculate the loop current value to enter.
Page 94
–
ST 700 Basic Transmitter -

to exit the Menu.
ST 700 SmartLine Pressure Transmitters User's Manual
Two-Button Option

in

Revision 8.0