Honeywell ST 700 User Manual page 126

19. Tighten the outside set screw to be sure it is fully seated in the slot in the header.
20. Loosen the set screw ½- turn.
21. Rotate the housing to the desired position (Max. 180
screw.
22. Carefully align and connect the Sensor Ribbon Cable to connector "J4" at the bottom of the
Communication module board. When installing the Communication module in the next step,
be careful not to pinch the Sensor Ribbon Cable.
23. Carefully, insert the Communication module into the Electronics compartment. Ensure that
the Sensor Ribbon Cable is not pinched.
24. Tighten the two Communication module retaining screws.
25. If applicable, re-install the Display module as follows:
d. Orient the display as desired.
e. Install the Interface Connector in the Display module such that it will mate with
the socket for the display in the Communication module.
f. Carefully line up the display, and snap it into place. Verify that the two tabs on
the sides of the display latch.
Orient the Display for proper viewing through the end cap window.
You can rotate the meter mounting orientation in 90 o increments.
26. Connect the bracket to the Transmitter housing.
27. Recalibrate the Transmitter per section Calibration_ST 700 Basic
document.
28. Return the Transmitter to service, and turn ON power
29. Verify the Transmitter configuration data. Restore the saved database if necessary.
30. Lubricate the end-cap O-ring with Parker Super O-ring silicone lubricant or equivalent before
replacing the end caps.
Page 112
ST 700 SmartLine Pressure Transmitters User's Manual
o
in either direction), and tighten the set
Transmitter, of this
Revision 8.0