Site Requirements - DataCard SD260 Installation And Administrator's Manual

Site Requirements

Set up and use the printer in an
environment that meets the following
requirements.
Provide space for the printer and for

clearance around the printer. The
printer dimensions and clearance area
are shown in the following table.
Printer
Model
SD160/SD260
SD260 with smart
card
Options such as a large output hopper and 200‐card input hopper add height to the printer.
Additional clearance is required when using these options.
Place the printer in an environment with temperatures ranging from 60° to 95°F (15° to 35°C).

Use a single‐phase, 3‐wire, grounded receptacle.

Place the system and its supplies in a clean office environment, keeping paper and foreign

materials off of the equipment.
Place the printer on a sturdy, level surface.

Place the printer away from direct sunlight.

Do not place the printer near heating ducts, fans, or other air vents.

Do not use the printer for purposes other than the intended use.

SD160/SD260 Installation and Administrator's Guide
A B
10.00 8.80 4.00
254 224
10.00 8.80 4.00
254 224
Dimensions (inches/mm)
C D
6.85 4.00
102 174 102
6.85 4.00
102 174 102
E F G
15.37 4.00
390 102
21.21 4.00
539 102
3