Ethernet Requirements; Usb Requirements; Electrical Requirements - DataCard SD260 Installation And Administrator's Manual

Ethernet Requirements

You can connect many network printers to one PC. The maximum number of printers depends on
the capacity of the network to deliver data to the printer.
To install an SD260 printer on a network, the following components are required:
An Ethernet network that uses the TCP/IP protocol and can run at 100 megabits per second,

also called 100base‐T. Printers also support 10base‐T.
An Ethernet cable to connect the printer to the network. An Ethernet cable is not supplied

with the printer.
A PC that meets the "PC Requirements" described on page

communicating with the network.

USB Requirements

You can connect up to eight card printers to a PC using USB cables.
To install a printer using a USB connection, the following components are required:
A high‐speed USB port. USB 2.0 is required.

A USB 2.0 cable to connect the printer to the PC. A USB cable is supplied with the printer.

A PC that meets the "PC Requirements" described on page

If you need to connect two card printers to a PC with one USB port, use a single, independently
powered USB hub to which you can connect both printers.

Electrical Requirements

The power supply detects the input voltage and works within the range stated.
Printer Model
SD160 or SD260
2
Electrical Requirements
Input
110–240V/50–60 Hz/1.5 Amp
1, and is connected to and
1.
Output
24V/3.0Amp/72W
Installation