DataCard SD260 Installation And Administrator's Manual page 62

KPower1200DPI—Modify the print intensity at 1200 dpi for the K panel or K ribbon.

Increase the value to make single‐color printing thicker and more defined on the card.

Decrease the value for crisp bar codes or to prevent frequent ribbon breaks when

printing with the K panel.
KPower600DPI—Modify the print intensity at 600 dpi for the K panel or K ribbon.

Increase the value to make single‐color printing thicker and more defined on the card.

Decrease the value for crisp bar codes or to prevent frequent ribbon breaks when

printing with the K panel.
KPowerDuplex—Modify the print intensity for the back‐side K panel and K ribbons.

Increase the value to make single‐color printing thicker and more defined on the card.

Decrease the value for crisp bar codes or to prevent frequent ribbon breaks when

printing with the K panel.
KWhiteShade—Modify the amount of power applied to the printhead to reduce ribbon

friction without transferring material. Decrease the value if material transfers to the card
when it should not.
LeadTrim—Modify the number of millimeters to remove from the leading edge of a full‐size

image to keep it within the print area (1 mm = 0.0394 in. or about 11.8 dot rows).
RewritableCardEnable—Enable or disable rewritable card printing.

RewritableCardType—Select the type of rewritable card you are using.

RewritableErasePasses—Specify the number of erase passes to make on a rewritable card

before reprinting. You may need to make multiple erase passes to remove the previously
printed information before printing on the card again. You can specify up to four erase
passes.
RewritableErasePower—Modify the erase power for a rewritable card, based on the card

type. Use this setting to fine‐tune the card appearance.
RewritableWritePower—Modify the write power for a rewritable card, based on the card

type. Use this setting to fine‐tune the card appearance.
Make sure that you test the RewritableErasePower and RewritableWritePower
settings by printing sample cards. Refer to "Testcard" on page
information about running a test card that tests the erase power.
SettingsGroupPurpose—State the purpose of a settings group. Group names are not

changeable. Use this option to identify the reason for creating a settings group.
48
58 for more
Printer Manager