Setting The Pause Length (Pause Time); Setting Automatic Redial (Auto Redial) - Canon IR3250 Reference Manual

Setting the Pause Length (Pause Time)

You can set the length (in seconds) of the dialing pause created when the [Pause] key is pressed.
NOTE
• If a pause is placed at the end of a telephone number, the pause length is fixed at 10 seconds.
• The factory setting is 2 seconds.
1
Call up the desired screen as follows:
Additional
key → [Communications Settings] → [Fax Settings] → [Pause Time]
Functions
2
Use the keypad or the [+] and [-] keys to
enter the pause length, then press the [OK]
key.
NOTE
• The pause length can be set from 1 to 15 sec-
onds.
Clear
• Press the key to cancel the setting.
3
Press the [Done] key.
Repeat until the Additional Functions screen closes.

Setting Automatic Redial (Auto Redial)

The Automatic Redial function automatically redials the recipient's number if the number is busy or a
connection cannot be established for any reason (i.e., a communication error).
NOTE
• The factory settings are:
- Auto Redial:
- Redial Times:
- Redial Interval:
- Redial after error:
1
Call up the desired screen as follows:
Additional
key → [Communications Settings] → [Fax Settings] → [Auto Redial]
Functions
On
2 times
2 minutes
Error and 1st page
Communications Settings 4-25