Skoda A7 Octavia Owner's Manual page 48

Refill amount After the consumption of about 10 litres of fuel from the fully
1)
refuelled tank, an amount of fuel is displayed in l. This amount can now be
safely refilled.
Natural gas qualityThe details of the quality of natural gas are displayed as a
percentage of between 70% to 100%. The higher the value of natural gas, the
lower is the consumption.
Coolant temperature - If the coolant temperature is in the range 70-120 °C,
the engine operating temperature has been reached. If the temperature is be-
low 70 ° C, high engine speeds and straining the engine should be avoided. If
the temperature is over 120 °C, the warning light  illuminates in the instru-
ment cluster » page 39.
It is possible, in Infotainment in the menu
show/hide the multifunction display menu items in the Instrument cluster dis-
play and to reset the journey data.
Infotainment display
›
In Infotainment in the menu

ta.
Screen display » Fig. 28
Distance travelled
A
Driving time
B
Average speed
C
Average fuel consumption
D
Transit point rating (DriveGreen Function)
E
1)
Only valid for some countries.
2)
For vehicles with CNG drive the approximate range with gasoline and CNG is displayed separately.
46
Operation
/  →  → Instrument cluster, to

Fig. 28
Journey data
/  tap the function surface  → Journey da-
Graphic fuel level display (if the estimated range is less than 300 km, the
F
vehicle starts to approach the symbol )
Approximate range
G
2)
Use the function surfaces   to select one of the following preset lists.
▶ Since start - Driving data for the individual trip
▶ Long-term - Long-term journey data
Since refuel - Data since refuelling
▶
Warning when exceeding the set speed
The system offers the possibility to set a speed limit beyond which an acoustic
warning signal will sound and the following warning message appears in the
display of the instrument cluster.
Adjust the speed limit while the vehicle is stationary
›
Select the menu item Warning at at () or  () and confirm.
›
Set the desired speed limit is 5 km/h steps.
›
Confirm the set value, or wait several seconds; your settings will be saved
automatically.
Adjusting the speed limit while the vehicle is moving
›
Select the menu item Warning at at () or  () and confirm.
›
Drive at the desired speed.
›
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
Reset the speed limit
›
Select the menu item Warning at at () or  () and confirm.
›
By confirming the stored value, the speed limit is reset.
The speed limit set mode is stored even after the ignition is switched off and
on. After a gap between driving exceeding 2 hours, the pre-set speed limit is
deactivated.