Skoda A7 Octavia Owner's Manual page 26

WARNING (Continued)
Safety belts must be checked to ensure that they are running properly.
■
One should also ensure that the belt is not damaged by sharp-edged fit-
tings.
When installing the child seat on the back seat, the corresponding front
■
seat must be adjusted so that there is no contact between the front seat
and the child seat or the child being transported in a child seat.
When installing a child seat in which the child faces forward, adjust the
■
head restraints so that they are as high as possible.
If the head restraints still prevent the child seat from being installed, even
■
in the highest position, you will need to remove them
moving the child seat, refit the head restraints.
Note
We recommend that you use child seats from ŠKODA Original Accessories.
These child seats were developed and also tested for use in ŠKODA vehicles.
They meet the ECE-R 44 standard.
Use of a child seat on the front passenger seat (variant 1)
Does not apply to Taiwan
Fig. 12 Warning labels
24
Safety

Read and observe
Never use a rearward-facing child restraint system on a seat which is pro-
tected by an active airbag. This could cause serious injury to the child, or
even death.
This is indicated also on stickers that are located at the following positions.
▶ On the passenger sun
▶ On the B-pillar on the front passenger side
The following instructions must be followed when using a child seat on the
front passenger seat.
» page 80. After re-
▶ The front passenger airbag must be deactivated if using a rear-facing child
seat
If possible, adjust the front passenger seat backrest so that it is as vertical, so
▶
as to ensure secure contact between the passenger seat backrest and the
back of the child seat.
▶ If possible, move the front passenger seat backwards so that there is no con-
tact between the front passenger seat and the child seat behind it.
▶ Set the height-adjustable front passenger seat as high up as possible.
Set the front passenger seat belt as high up as possible.
▶
With child safety seats in groups 2 and 3, make sure that the loop-around fit-
▶
tings attached to the child seat headrest is positioned in front of or at the
same height as the loop-around fittings on the B pillar on the passenger side.
Adjust the height of the front passenger seat belt so that the belt does not
"jam" in the return pulley. In the event of an accident, there is the risk of in-
jury to the neck of the child carried due to the seat belt!
WARNING
Never use a rear-facing child seat on the front passenger seat if the pas-
■
senger airbag is activated. This child safety seat is positioned in the deploy-
ment area of the front passenger airbag. The airbag may cause the child se-
vere, or even fatal injuries, in the event of it being deployed.
As soon as the child seat, in which the child is transported with their back
■
in the direction of travel, is no longer used in the front passenger seat, the
front passenger airbag should be switched on again.
on page 23 first.
visor» Fig. 12 - .
» .
» Fig. 12 – .