Fig. 354 Connector removal variants
Read and observe
and
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel trims into opening
» Fig.
353.
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws
with the key from the tool kit.
B
›
Hold the light and carefully remove in the direction of arrow
›
Remove connector
.
C
Remove the plug
The connector type varies according to the vehicle version
›
For connectors with lateral safety tabs, push these in the direction of arrows
or
and remove the connector carefully.
A
B
›
For connectors with removable safety tabs
arrow
, press the safety tabs in the direction of arrow
1
connector carefully.
Fitting
›
Insert the bulb holder into the lamp. The safety tabs on the connector must
lock into place.
›
Insert the lamp with pins
» Fig. 353
D
›
Carefully push the cover in
»
›
Screw the tail lamp into place and install the cover. The cover must engage
securely.
1)
The position of the opening may vary depending on the vehicle model.
306
Do-it-yourself
on page 303 first.
2
» Fig.
354.
, pull these in the direction of
C
and remove the
2
into the recesses
in the body.
E
.
›
Shut the boot lid.
CAUTION
Ensure that the cable bundle does not become stuck between the body and
■
the lamp when it is being refitted – or there is a risk of damage to the electrical
installation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we rec-
■
ommend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing the bulbs in the tail lamp assembly - Variant 1
A
1)
.
1
.
Fig. 355 Outer part of the lamp/inner part of the lamp with bulbs
Read and observe
›
Unscrew the lamp holder
kit, and remove the lamp holder from the light assembly.
›
Turn the respective bulb anti-clockwise until it stops and remove it from the
bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Insert the bulb holder into the light and screw in.
and
on page 303 first.
» Fig. 355
with the screwdriver from the car tool