Table of Contents
Advertisement
A route destination
In the route plan, the following information is displayed at the destina-
tion» Fig. 219
- .
Area with function surfaces
A
Destination information
B
Estimated time of arrival at destination / remaining driving time to desti-
nation
1)
Remaining distance to the destination
Chosen route type (economic, fastest, shortest)
C
Current vehicle position (address / GPS coordinates)
D
The display of the arrival time or the remaining driving time can be adjusted as
follows.
▶
In the Navigation main menu, tap on function surface → Advanced settings →
Time display:.
Several route destinations
In the route plan, the following information is displayed at the respective desti-
nations» Fig. 219
- .
Area with function surfaces
A
Stopover (with sequential number)
Final destination
Estimated time of arrival at destination / stopover
Driving distance to destination / stopover
Change destinations with each other
Delete the destination
Continuation of the route guidance from the selected target (previous
waypoints are skipped)
Display the destination details
Insert destination into the route
In the area
Enter dest. Tap the function surface and enter a new destina-
▶
A
tion.
▶
orTap on the area
the functional surface destinations and select a destina-
A
tion in the list of stored destinations.
1)
If the time of arrival to the final destination or remaining travelling time greater than 24 hours, is displayed
inside the symbol.
190
Infotainment
» page 187
Each additional destination is added to the list as the first subsequent destina-
tion route.
Change positions of destinations with each other
▶
The relevant function surface and move the destination to the desired po-
sition.
With destinations on the route already reached the note Dest. reached is dis-
played below the destination name. It is not possible to change the position of
these destinations with each other.
Store route
In the area
, tap the function surface Save.
▶
A
▶
Save the edited route as a new route or replace the existing saved route.
The route is stored in the route list
Stop route guidance
▶
In the area
, tap the function surface stop .
A
Route change in the map
Only valid for Infotainment Columbus.
Fig. 220 Route change in the map / route transit point
A route in which no waypoints are contained, can be changed during route
guidance by adding a transit point.
Add a transit point
›
In the Navigation main menu, tap on function surface → Change route in map.
» page
191.
- Quick Links:
- Engine Oil
Hide quick links:
Advertisement
Table of Contents
