WARNING
Always read and observe the warnings before completing any work in the
■
engine compartment
» page
272.
Accidents can be caused if the road in front of the vehicle is not suffi-
■
ciently illuminated and the vehicle cannot or can only be seen with difficulty
by other road users.
H7 and H8 bulbs are pressurised and may burst when changing the bulb -
■
risk of injury! We therefore recommended wearing gloves and safety
glasses when changing a bulb.
CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
■
amount of dirt reduces the working life of the light bulb). Use a clean cloth,
napkin, or similar.
The cap of the filament bulb must always be seated correctly in the head-
■
light, otherwise this may allow water and debris to enter the headlight - risk of
damage to the headlights.
Note
We recommend that a box of replacement bulbs always be carried in the vehi-
cle.
Bulb arrangement in the halogen headlights
Read and observe
and
Bulb arrangement
» Fig. 348
Low beam
A
Main beam
B
Fig. 348
Left headlight
on page 303 first.
Changing the bulb for the low beam
Fig. 349 Changing the bulb for the low beam
Read and observe
and
›
Turn the protective cap
» Fig. 348
A
›
Disconnect the connector with the light bulb in the direction of arrow
» Fig.
349.
›
Remove the connector to the bulb in the direction of arrow
›
Remove the connector.
›
Plug the connector into the new bulb so that the fixing lug
points upwards.
›
Insert the connector, with the bulb, into the headlight opposite to the direc-
tion of arrow
until you feel it lock into place.
2
›
Insert the protective cap
» Fig. 348
A
the direction of the arrow.
on page 303 first.
on page 303 in direction of the arrow.
.
2
on the bulb
A
on page 303 and turn it opposite to
Fuses and light bulbs
1
303