Layer 3 Static Aggregation Configuration Example - HP 6125XLG Configuration Manual

--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
The output shows that Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 are in Individual state
when they do not receive any LACPDUs from the server. Both Ten-GigabitEthernet 1/1/5 and
Ten-GigabitEthernet 1/1/6 can forward packets, so that zero packet loss is guaranteed.

Layer 3 static aggregation configuration example

Network requirements
On the network shown in
• Configure a Layer 3 static aggregation group on both Device A and Device B.
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
•
Figure 16 Network diagram
Configuration procedure
1. Configure Device A:
# Create Layer 3 aggregate interface Route-Aggregation 1, and configure an IP address and
subnet mask for the aggregate interface.
<DeviceA> system-view
[DeviceA] interface route-aggregation 1
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
[DeviceA-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces Ten-GigabitEthernet 1/1/5 through Ten-GigabitEthernet
1/1/7 to aggregation group 1.
[DeviceA] interface ten-gigabitethernet 1/1/5
[DeviceA-Ten-GigabitEthernet1/1/5] port link-aggregation group 1
[DeviceA-Ten-GigabitEthernet1/1/5] quit
[DeviceA] interface ten-gigabitethernet 1/1/6
[DeviceA-Ten-GigabitEthernet1/1/6] port link-aggregation group 1
[DeviceA-Ten-GigabitEthernet1/1/6] quit
[DeviceA] interface ten-gigabitethernet 1/1/7
[DeviceA-Ten-GigabitEthernet1/1/7] port link-aggregation group 1
[DeviceA-Ten-GigabitEthernet1/1/7] quit
2. Configure Device B in the same way Device A is configured. (Details not shown.)
Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
0 32768 0
0 32768 0
Figure 16, perform the following tasks:
65
0x8000, 0000-0000-0000 {DEF}
0x8000, 0000-0000-0000 {DEF}