Assigning A Trunk Port To A Vlan - HP 6125XLG Configuration Manual

Step
2. Enter interface view.
3. Configure the link type of the
ports as access.
4. (Optional.) Assign the access
ports to a VLAN.

Assigning a trunk port to a VLAN

A trunk port can allow multiple VLANs. You can assign it to a VLAN in interface view.
When you assign a trunk port to a VLAN, follow these restrictions and guidelines:
To change the link type of a port from trunk to hybrid or vice versa, set the link type to access first.
•
You must configure the trunk port to allow packets from the PVID to pass through by using the port
•
trunk permit vlan command.
To assign a trunk port to one or multiple VLANs:
Step
1. Enter system view.
Command
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter S-channel interface
view:
interface s-channel
interface-number.channel-id
•
Enter S-channel aggregate
interface view:
interface
schannel-aggregation
interface-number:channel-id
port link-type access
port access vlan vlan-id
Command
system-view
138
Remarks
•
The configuration made in Layer 2
Ethernet interface view applies
only to the port.
•
The configuration made in Layer 2
aggregate interface view applies
to the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to an aggregation
member port, it skips the port and
moves to the next member port. If
the system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports.
•
The configuration made in
S-channel interface view or
S-channel aggregate interface
view applies only to the interface.
For more information about
S-channel interfaces, see EVB
Configuration Guide.
By default, all ports are access ports.
By default, all access ports belong to
VLAN 1.
Remarks
N/A