Layer 2 Dynamic Aggregation Configuration Example - HP 6125XLG Configuration Manual

Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
XGE1/1/7
The output shows that link aggregation group 1 is a Layer 2 static aggregation group and it contains
three Selected ports.

Layer 2 dynamic aggregation configuration example

Network requirements
On the network shown in
• Configure a Layer 2 dynamic aggregation group on both Device A and Device B.
Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end.
•
Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the other end.
•
Figure 13 Network diagram
Configuration procedure
1. Configure Device A:
# Create VLAN 10, and assign the port Ten-GigabitEthernet 1/1/8 to VLAN 10.
<DeviceA> system-view
Status Priority Oper-Key
S 32768 1
S 32768 1
S 32768 1
Figure 13, perform the following tasks:
59