Displaying And Maintaining Super Vlans; Super Vlan Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

Displaying and maintaining super VLANs

Execute the display command in any view.
Task
Display information about super VLANs and their
associated sub-VLANs.

Super VLAN configuration example

Network requirements

As shown in
Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 are in VLAN 2.
•
• Ten-GigabitEthernet 1/1/7 and Ten-GigabitEthernet 1/1/8 are in VLAN 3.
Ten-GigabitEthernet 1/1/9 and Ten-GigabitEthernet 1/1/10 are in VLAN 5.
•
To save IP addresses and enable sub-VLANs to be isolated at Layer 2 but interoperable at Layer 3,
configure the super VLAN feature as follows:
Create super VLAN, and assign an IP address to its VLAN interface.
•
Associate the super VLAN with sub-VLANs 2, 3, and 5.
•
Figure 43 Network diagram

Configuration procedure

# Create VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ip address 10.0.0.1 255.255.255.0
# Enable local proxy ARP.
[Sysname-Vlan-interface10] local-proxy-arp enable
Figure 43:
Command
display supervlan [ supervlan-id ]
153