Configuring The Loop Protection Action; Configuring The Global Loop Protection Action; Configuring The Loop Protection Action On A Layer 2 Ethernet Interface; Configuring The Loop Protection Action On A Layer 2 Aggregate Interface - HP 6125XLG Configuration Manual

Step
2. Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view.
3. Enable loop detection on the
port.

Configuring the loop protection action

You can configure the loop protection action globally or on specific ports. The global configuration
applies to all ports. The per-port configuration applies to the individual ports. The per-port configuration
takes precedence over the global configuration.

Configuring the global loop protection action

Step
1. Enter system view.
2. Configure the global loop
protection action.
Configuring the loop protection action on a Layer 2 Ethernet
interface
Step
1. Enter system view.
2. Enter Layer 2 Ethernet interface
view.
3. Configure the loop protection
action on the interface.
Configuring the loop protection action on a Layer 2 aggregate
interface
Step
1. Enter system view.
2. Enter Layer 2 aggregate
interface view.
Command
interface interface-type
interface-number
loopback-detection enable vlan
{ vlan-list | all }
Command
system-view
loopback-detection global action
shutdown
Command
system-view
interface interface-type
interface-number
loopback-detection action { block |
no-learning | shutdown }
Command
system-view
interface bridge-aggregation
interface-number
128
Remarks
N/A
Disabled by default.
Remarks
N/A
By default, the switch generates a
log but performs no action on the
port on which a loop is detected.
Remarks
N/A
N/A
By default, the switch generates
a log but performs no action on
the port on which a loop is
detected.
Remarks
N/A
N/A