To do...
Display the global or group-
specific link-aggregation load
sharing criteria
Display detailed link aggregation
information on link aggregation
member ports
Display the summary of all
aggregation groups
Display detailed information
about a specific or all
aggregation groups
Clear LACP statistics for a specific
or all link aggregation member
ports
Clear statistics for a specific or all
aggregate interfaces
Ethernet link aggregation configuration examples
In an aggregation group, only ports that have the same port attributes and class-two configurations
(see
"Configuration
You must ensure that all member ports have the same port attributes and class-two configurations as the
reference port. The other settings only need to be configured on the aggregate interface, not on the
member ports.
Layer 2 static aggregation configuration example
Network requirements
As shown in
Figure
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces
•
GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
Configure a Layer 2 static link aggregation group on Device A and Device B. Then enable VLAN 10
•
at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at
one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination MAC addresses.
Use the command...
display link-aggregation load-sharing mode
[ interface [ bridge-aggregation interface-
number ] ] [ | { begin | exclude | include }
regular-expression ]
display link-aggregation member-port
[ interface-list ] [ | { begin | exclude | include }
regular-expression ]
display link-aggregation summary [ | { begin |
exclude | include } regular-expression ]
display link-aggregation verbose [ bridge-
aggregation [ interface-number ] ] [ | { begin |
exclude | include } regular-expression ]
reset lacp statistics [ interface interface-list ]
reset counters interface [ bridge-aggregation
[ interface-number ] ]
classes") as the reference port (see
14:
"Reference
port") can operate as selected ports.
49
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in any
view
Available in user
view
Available in user
view