Layer 2 Aggregation Load Sharing Configuration Example - HP 6125XLG Configuration Manual

XGE1/1/6
XGE1/1/7
Remote:
Actor
--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
XGE1/1/7
The output shows that link aggregation group 1 is a Layer 2 dynamic aggregation group and it contains
three Selected ports.

Layer 2 aggregation load sharing configuration example

Network requirements
On the network shown in
Configure two Layer 2 static aggregation groups 1 and 2 on Device A and Device B, respectively.
•
Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end.
•
Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the other end.
•
• Configure link aggregation groups 1 and 2 to load share traffic across aggregation group member
ports.
Configure link aggregation group 1 to load share traffic based on source MAC addresses.
Configure link aggregation group 2 to load share traffic based on destination MAC addresses.
Figure 14 Network diagram
Configuration procedure
1. Configure Device A:
# Create VLAN 10, and assign the port Ten-GigabitEthernet 1/1/9 to VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] port ten-gigabitethernet 1/1/9
[DeviceA-vlan10] quit
# Create VLAN 20, and assign the port Ten-GigabitEthernet 1/1/10 to VLAN 20.
S 32768
S 32768
Partner Priority Oper-Key
1 32768
2 32768
3 32768
Figure 14, perform the following tasks:
1 {ACDEF}
1 {ACDEF}
SystemID
1 0x8000, 000f-e267-57ad {ACDEF}
1 0x8000, 000f-e267-57ad {ACDEF}
1 0x8000, 000f-e267-57ad {ACDEF}
61
Flag