Configuration Procedures - HP 6125XLG Configuration Manual

BEB 1 connects to the core network through Ten-GigabitEthernet 1/1/5, and it connects to Device
•
A in customer network A through Ten-GigabitEthernet 1/1/6.
BEB 2 connects to the core network through Ten-GigabitEthernet 1/1/5, and it connects to Device
•
B in customer network B through Ten-GigabitEthernet 1/1/6.
Configure PBB to enable customer network A to communicate with customer network B.
Figure 67 Network diagram

Configuration procedures

Configure BEB 1:
1.
# Create VLAN 20.
<BEB1> system-view
[BEB1] vlan 20
[BEB1-vlan20] quit
# Enable L2VPN.
[BEB1] l2vpn enable
# Create a VSI of the PBB type named aaa.
[BEB1] vsi aaa
# Specify the I-SID as 1.
[BEB1-vsi-aaa] pbb i-sid 1
# Configure Ethernet encapsulation for the PBB VSI.
[BEB1-vsi-aaa-1] encapsulation ethernet
# Specify B-VLAN 20 for PBB VSI aaa.
[BEB1-vsi-aaa-1] bvlan 20
[BEB1-vsi-aaa-1] quit
[BEB1-vsi-aaa] quit
# Configure Ten-GigabitEthernet 1/1/5 as a trunk port, assign it to VLANs 20, and configure it as
an uplink port of PBB VSI aaa.
[BEB1] interface ten-gigabitethernet 1/1/5
[BEB1-Ten-GigabitEthernet1/1/5] port link-type trunk
[BEB1-Ten-GigabitEthernet1/1/5] port trunk permit vlan 20
[BEB1-Ten-GigabitEthernet1/1/5] pbb uplink vsi aaa
[BEB1-Ten-GigabitEthernet1/1/5] quit
229