Configuring An Aggregate Interface; Setting The Description For An Aggregate Interface; Specifying Ignored Vlans For A Layer 2 Aggregate Interface - HP 6125XLG Configuration Manual

Configuring an aggregate interface

In addition to the configurations in this section, most of the configurations that can be performed on Layer
2 or Layer 3 Ethernet interfaces can also be performed on Layer 2 or Layer 3 aggregate interfaces.

Setting the description for an aggregate interface

You can set the description for an aggregate interface for administration purposes, for example,
describing the purpose of the interface.
To set the description for an aggregate interface:
Step
1. Enter system view.
2. Enter aggregate
interface view.
3. Set the description for
the aggregate interface.

Specifying ignored VLANs for a Layer 2 aggregate interface

By default, to become Selected ports, the member ports must have the same VLAN permit state and
VLAN tagging mode as the corresponding Layer 2 aggregate interface.
The system ignores the permit state and tagging mode of an ignored VLAN when choosing Selected
ports.
To specify ignored VLANs for a Layer 2 aggregate interface:
Step
1. Enter system view.
2. Enter Layer 2 aggregate
interface view.
3. Specify ignored VLANs.
Command
system-view
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface
or subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
description text
Command
system-view
interface bridge-aggregation
interface-number
link-aggregation ignore vlan
vlan-id-list
49
Remarks
N/A
N/A
By default, the description of an
interface is interface-name Interface.
Remarks
N/A
N/A
By default, a Layer 2 aggregate
interface does not ignore any
VLANs.