Configuration Procedure; Digest Snooping Configuration Example - HP 6125XLG Configuration Manual

Configuration procedure

Use this feature on when your HP device is connected to a third-party device that uses its private key to
calculate the configuration digest.
To configure Digest Snooping:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet or
aggregate interface view.
3. Enable Digest Snooping on
the interface.
4. Return to system view.
5. Enable Digest Snooping
globally.

Digest Snooping configuration example

Network requirements
As shown in
these devices are in the same region.
Enable Digest Snooping on the ports of Device A and Device B that connect to Device C, so that the three
devices can communicate with one another.
Figure 26 Network diagram
Configuration procedure
# Enable Digest Snooping on Ten-GigabitEthernet 1/1/5 of Device A and enable global Digest
Snooping on Device A.
<DeviceA> system-view
Figure 26, Device A and Device B connect to Device C, which is a third-party device. All
Command
system-view
interface interface-type
interface-number
stp config-digest-snooping
quit
stp global config-digest-snooping
108
Remarks
N/A
N/A
By default, Digest Snooping is
disabled on ports.
N/A
By default, Digest Snooping is
disabled globally.