Brother D800W User Manual page 49

Printing a Label Using the P-touch Labelling Machine Keyboard
Punch-Down Block
Labels of this type can be used to identify a type of electrical connection, often used in telephony. You can
enter up to eight lines for each block on a single label.
 Module Width: 200 mm, 50-300 mm
 Block Type: 4 Pairs, 2 Pairs, 3 Pairs, 5 Pairs, Blank
Sequence Type:

 Start Value: ---, 1-99999
Note
• When "Blank" is selected in "Block Type", "Sequence Type" is set to "None".
• When "None" is selected in "Sequence Type", "---" appears for "Start Value" and you cannot set a
value. Selecting "Horizontal" or "Backbone" however, allows you to set the "Start Value" setting from
1 to 99,999.
Die-cut Flag
Labels of this type can be printed on special die-cut flag labels to create flag labels for cables and wires.
Use FLe label cassettes for this type of application.
 Layout: (same text in different directions on each side),
(same text in same direction on each side),
(different text in different directions on each side),
(different text in same direction on each side)
 Orientation: (Horizontal),
(None), (Horizontal),
(Vertical)
(Backbone)
2
2
2
38