Dust Collection; Test Run - Grizzly G0813 Owner's Manual

Dust Collection

This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect dust collection hose:
1.
Fit 4" dust hose over dust port, as shown in
Figure 42, and secure with a hose clamp.
Figure 42. Example of dust hose attached to
dust port.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Model G0813/G0814 (Mfd. Since 3/16)

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious personal injury could occur from
connecting machine to power before
completing the setup process described in
this manual. DO NOT connect power until
instructed to do so later in this manual.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run the machine:
1.
Clear all setup tools away from machine.
2.
Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
-29-