Grizzly G0813 Owner's Manual page 30

Cutterhead guard must always return to
closed position whenever it is moved. If it
does not do this, it must be re-adjusted or
re-installed.
34. Test operation of guard by pulling it back.
Guard should spring back over cutterhead
and stop against fence.
— If guard does not snap back, or snaps
back slowly, remove guard and repeat
Steps 32–34.
35. Install belt guard with (1)
bolt and (1) ⁄ " flat washer (see Figure 39).
5
16
x 1
Figure 39. Belt guard installed.
-28-
⁄ "-18 x 2 ⁄ " hex
5 1
16 2
36. Assemble knife-setting gauge, as shown in
Figure 40.
Figure 40. Knife-setting gauge assembled.
37. Install dust port, as shown in Figure 41, using
(4) #10-24 x ⁄ " flange screws.
3
4
Figure 41. Dust port installed.
Model G0813/G0814 (Mfd. Since 3/16)
x 4