Assembly - Grizzly G0813 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather all
listed items. To make sure the assembly process
goes smoothly, first clean all parts that have any
heavy-duty rust preventative applied by the fac-
tory (if applicable).
The Model G0813 jointer stand must be assem-
bled. The Model G0814 stand requires no assem-
bly. Therefore, if assembling the Model G0813,
start at Step 1. If assembling the Model G0814,
start at Step 18 on Page 25.
To assemble jointer:
1. Place top plate upside down on level surface,
then attach left and right chute supports to
top plate with (4) #10-24 x
and #10-24 hex nuts, as shown in Figure 15.
Ensure flanges face outward.
Left
Support
Top Plate
x 4
Figure 15. Dust chute supports attached to top
plate.
-22-
⁄ " flange screws
3
8
Flange
Right Support
2. Hold motor mount plate level, attach it to top
of chute supports with (2) #10-24 x
screws, then pivot plate down and install
(4) #10-24 x ⁄ " additional flange screws
3
8
(see Figure 16).
Note: Flange screws must be installed from
inside of chute supports.
x 6
Chute
Support
Figure 16. Motor mount plate attached to chute
supports.
3. Attach motor to base so pulley is aligned with
belt slot in top plate using (4)
carriage bolts, (4)
⁄ "-18 hex nuts (see Figure 17).
5
16
Note: Do not tighten any fasteners until
further instructed.
Pulley
Belt Slot
Figure 17. Motor attached to dust chute base.
Model G0813/G0814 (Mfd. Since 3/16)
⁄ " flange
3
8
Motor
Mount
Plate
⁄ "-18 x
5
16
⁄ " flat washers, and (4)
5
16
x 4
Dust Chute
Base
⁄ "
3
4