Squaring Stock - Grizzly G0813 Owner's Manual

Squaring Stock

Squaring stock involves four steps performed
in the order below:
1. Surface Plane on Jointer—Concave face of
workpiece is surface planed flat with jointer.
2. Surface Plane on a Thickness Planer—
Opposite face of workpiece is surface planed
flat with a thickness planer.
Previously Surface
Planed Face
-34-
3. Edge Joint on Jointer—Concave edge of
workpiece is jointed flat with jointer.
4. Rip Cut on a Table Saw—Jointed edge
of workpiece is placed against a table saw
fence and opposite edge cut off.
Model G0813/G0814 (Mfd. Since 3/16)
Previously
Jointed
Edge