Absolute Pressure Sensor) - Suzuki Grand Vitara XL-7 Service Manual

Hide thumbs Also See for Grand Vitara XL-7:

Table of Contents

6E3-42 ENGINE AND EMISSION CONTROL SYSTEM (RHZ ENGINE)

INTAKE AIR PRESSURE SENSOR (MANIFOLD

ABSOLUTE PRESSURE SENSOR)

1) Disconnect negative cable at battery.

2) Disconnect connector from intake air pressure sensor (1).

3) Remove intake air pressure sensor from strut tower bar.

1) Arrange 3 new 1.5 V batteries (2) in series and connect its posi-

tive terminal to "Vin" terminal of coupler and negative terminal to

"Ground" terminal. Then check voltage between "Vout" and

Also, check if voltage reduces when vacuum is slowly applied up

to 400 mmHg by using vacuum pump (3).

As connection to wrong terminal will cause damage to in-

take air pressure sensor, make absolutely sure to con-

nect properly as shown in left figure.

Output voltage (When sensor input voltage is 4.5 – 5.5 V,

ambient temp. 20 – 30_C, 68 – 86_F)

If check result is not satisfactory, replace intake air pressure sen-

INSTALLATION

Before installing intake air pressure sensor hose, degrease

connect part of hose and intercooler outlet hose. Otherwise

hose may become detached and cause turbo system failure.

1) Install intake air pressure sensor (1) to strut tower bar.

2) Connect connector and hose to intake air pressure sensor se-

3) Connect negative cable at battery.

Table of Contents