Table of Contents
Advertisement
4
Model 3360SE Terminal
Installation
This section discusses the procedures for installing the 3360SE terminal. The
terminal can be freestanding or, optionally, mounted on a wall. The paragraphs
below describe how to connect and set up the terminal in both configurations.
Locating the Terminal
Position the terminal on a clean, horizontal surface that is free from vibration and
out of direct sunlight. Refer to "Windows-based Terminal Specifications" for
environmental specifications.
Connecting the Terminal
Make all connections to the back panel before connecting the terminal to power. An
optional shroud and cable retaining loop (described in "Optional Cable Retaining
Clip and Shroud Installation") can be installed after the cables are connected and
the terminal is mounted in place. Figure 4-1 shows the back panel connectors.
Note
Optional wall-mount and cable shroud kits (P/N
920190-01 and P/N 830167-01) are available. For
more information call 1-800-800-WYSE (9973).
Note
A keyboard and AC power cord are supplied with U.S.
models only.
Hide quick links:
Advertisement
Table of Contents
