Table of Contents
Advertisement
INSTALLATION
Please read the following procedures and precautions before turning on the
terminal.
1.
If
you have not already unpacked the terminal, carefully remove it from the
container. Save all packing materials in case the terminal must be shipped
or stored.
Caution: Sharp instruments should not be used to open the container.
Immediately notify the transfer company, if there is any damage.
2.
Place the terminal on any sturdy table or desk.
3.
Set the ON/OFF power switch on the front of the video module base to OFF
by pushing the bottom of the switch.
4.
Connect the keyboard cable to its receptacle on the video module base.
5.
First connect the power cord to its receptacle on the video module base.
Then plug it into a nearby three-pronged, grounded electrical outlet.
6.
Connect the host computer communications cable to the modem port (see
"Connector Pin Assignments").
Note: All the connectors are keyed so that connections can only be made in
the correct way.
The WY-75 has a female RS-232C connector that requires a male RS-232C
connector on the host interface cable. This is opposite the VT-lOO
connectors.
7.
Connect the printer communications cable, if required, to the auxiliary port.
2
Installation
Advertisement
Table of Contents
