Wyse Winterm 3200LE Administrator's Manual page 297

Reset your terminal:
1. Press F2 on your keyboard to invoke the Terminal Properties dialog box.
2. Click on (to check) the Reset the Terminal to Factory Default Property
Settings check box.
3. Click on Yes in the System Settings Change dialog box.
or
Reset the terminal to factory default by performing the following steps while the
power is still on and while holding down the G key on the keyboard of your
terminal:
1. Press and hold the power management button until the LED turns to amber
(approximately 3 to 5 seconds).
2. Release the power management button.
3. Wait approximately 7 seconds for the system to reboot.
4. Wait for the Setup wizard to display, then release the G key.
The terminal is reset to factory defaults.
Determine the size of the onboard memory:
1. Press F2 on your keyboard to invoke the Terminal Properties dialog box.
2. Read the firmware revision number listed in RAM: on the General properties
sheet.
3. Click on the Close command button on the General properties sheet to
return to Winterm Connection Manager.
Configure a local printer:
If you are using the Winframe 1.7/ICA platform:
1. Log in to your Winframe server.
2. Click on Print Manager in Program Manager.
3. Click on Connect to Printer on the Printer menu.
4. Click on Client Network, then Client on the Shared Printer menu.
5. Select your <clientname#port>, then click on OK.
265